Honeycomb activated carbon brick
Honeycomb activated carbon uses high-quality coal-based activated carbon as the raw material, and is pressed by a bee mold and fired at high temperature.
Uses of honeycomb activated carbon:
Honeycomb activated carbon can be widely used in various gas purification equipment and exhaust gas treatment projects. Practice has proved that the purification effect is better than ordinary. The pollutants that can be removed with honeycomb activated carbon to different degrees are: nitric oxide, carbon tetrachloride, chlorine, benzene, diformaldehyde, acetone, ethanol, ether, methanol, acetic acid, ethyl ester, styrene, phosgene, and malodorous gases. Alkali gas.
Characteristics of honeycomb activated carbon:
Honeycomb activated carbon has the characteristics of large area, small through-hole resistance, developed micropores, high adsorption capacity, and long service life. It is widely used in air pollution control. The honeycomb activated carbon adsorption method is used, that is, the exhaust gas is in contact with porous activated carbon with a large surface, and the pollutants in the exhaust gas are adsorbed and decomposed, thereby playing a purification role.
Instructions for use of honeycomb activated carbon:
Can be used directly or placed in purification cabinets and adsorption beds. If the exhaust gas concentration is high and the emissions are large, two purification cabinets and adsorption beds can be used alternately. During use, try to avoid too high temperature, too high temperature will reduce the amount of adsorption, the amount of adsorption will decrease as the temperature rises; at the same time to avoid high dust content and oil mist, because tar dust mist will block the activated carbon micropores, increase resistance Reduce the adsorption effect. If the use environment contains a large amount of thick dust and tar, you should install pre-dust filtration to achieve the best use effect and longest service life.
Index of honeycomb activated carbon:
Normal compressive strength: more than 0.8MPa
Common specifications: 50 * 50 * 100mm, 100 * 100 * 100mm
Use temperature: less than 400 degrees Celsius
Hole density: 100 holes / square inch, 150 holes / square inch
Air tower wind speed: 0.8 m / s